On October 16 and 20, FEMA held informational webinars to help broadcasters prepare for the upcoming National EAS Test on November 17, 2026, at 2:20 p.m. ET. (If the test needs to be postponed because of a major event, the backup test date is December 3, 2026.) What follows is a summary of those events with highlights of the key takeaways.
This will be an EAS-only test. No Wireless Emergency Alerts (WEA) will be sent. The test message will originate from FEMA through the IPAWS CAP feed and be distributed via internet-connected EAS equipment. Both English and Spanish audio/text will be available. Broadcasters should configure their equipment appropriately. The expected test duration is approximately one minute.
The primary delivery mechanism for the test is the IPAWS CAP feed via the internet. A secondary path exists through traditional over-the-air EAS monitoring, which provides redundancy. It is possible your station may receive the alert from a monitored broadcast source before receiving it directly from IPAWS due to the polling intervals. Do not be surprised if this happens at your station. Keep in mind that CAP-triggered polling enhancements apply to state and local alerts, but not to NPT or Emergency Action Notification (EAN) messages.
Broadcaster Readiness Checklist
Verify Monitoring Paths
- Confirm receipt of:
- Weekly IPAWS CAP tests (RWTs)
- Required Monthly Tests (RMTs)
- Over-the-air monitoring sources
- Missing CAP tests may indicate connectivity or configuration problems.
Review Logs
- Check logs for:
- CAP-based alerts
- Over-the-air alerts
- Activity from all assigned monitoring sources
- Ensure monitoring assignments match the state EAS plan.
Verify Audio Quality
- Do not rely solely on successful log entries.
- Listen to recorded alerts for distortion, hum, static, weak signals, improper audio levels
- A successful decode does not guarantee usable alert audio.
Check Audio Levels
- Verify all monitoring inputs meet manufacturer recommendations.
- Audio levels that are too low or too high can affect alert quality and decoding reliability.
Critical Test-Day Expectations
- NPT messages must be automatically and immediately retransmitted upon receipt.
- Delaying or suppressing the test can:
- Violate requirements
- Impact downstream broadcasters
- Cause regional test failures
- Stations are encouraged to have an engineer or operator monitor the test live if possible.
The following Equipment-Specific Guidance was also provided.
Sage ENDEC
- Verify software version is at least 96-00.
- Use the Verify REC
- Confirm:
- CAP connectivity (“CAP OK” status)
- Email reports are functioning
- National location code (000000) is enabled
DASDEC
- Ensure firmware is current.
- Verify CAP connectivity and over-the-air monitoring sources.
- Confirm immediate NPT relay configuration.
Keep in mind the following ETRS filing deadlines:
- Form 1: Due by October 30, 2026.
- Form 2: Due within 48 hours after the test.
- Form 3: Post-test report including observations, issues, and comments.
What will the public experience? Radio listeners will hear the EAS header tones, the attention signal, the test message and the end-of-message tones. Television viewers will see a visual crawl/text and hear an audio message that will interrupt the current program carrying the alert audio. FEMA emphasizes that TV stations must transmit both the visual and audio portions of the message.
As an FYI, Congress requires FEMA to test the public alert and warning system at least once every three years. The last nationwide test occurred in 2023. All radio and TV broadcasters are required to immediately retransmit the National Periodic Test (NPT). Participants must comply with FCC ETRS (EAS Test Reporting System) reporting requirements.
The post FEMA National EAS Test Preparation Webinar Overview appeared first on The Society of Broadcast Engineers.